Cut out the old caulk with a utility knife. Turn the water back on at the supply line valves. THE PROJECT 1 Cut open the caulking tube at an angle, and pierce the seal inside the nozzle with the caulking gun’s provided piercer or the tip of a wire hanger if your gun doesn’t come with one. Inserting the faucet is probably the most crucial part of the whole process. Apply painter’s tape to mask off areas around the joint where the caulk should not appear. We say this because the new caulk will not stick to your old caulk neither will it stay on wet surfaces. A proper seal around your kitchen sink prevents water from seeping down below and destroying your kitchen cabinets. Run your fingers around the tape and press it down firmly. If necessary, remove the old collar by unscrewing it from the drain rim beneath the sink, after disconnecting the P-trap, using tongue-and-groove pliers. Hold the scraper at an angle so as not to damage the tub or faucet surface (a). Finally, you must leave your sink dry and unused for 24 hours, for the caulk to set in. • Wash the entire area with a disinfectant cleaner and let it dry thoroughly. Note: When learning how to install a bathroom faucet, always use the instructions enclosed with your particular faucet, as specific steps can vary between models.
It’s applied along the joints where your sink meets your countertop to stop water and gunk from getting into the gaps.
These are very easy to pick up from hardware stores, and • If there is considerable caulk residue that you’re having trouble removing with the razor scraper, try a caulkremover product. Prepare the Caulk. the nozzle at 45 degrees, more or less. Take a blade and cut Grasp the tube and squeeze with enough pressure to force the caulk into the joint. If you’re removing. Use an adjustable wrench to disconnect the water supply lines. Prepare the Surface. Countertops are expensive and cut fingers hurt and take time to heal! PREP WORK • Using the razor scraper, carefully scrape away the old caulking. If you’re happy with your work, take your finger and run it along to the top of caulk, all around the sink, to smooth it out and give it that professional look. Insert the caulk tube into the caulk gun after cutting off its tip. I should make sure to save the leftover caulk in case I do mess it up though. How to Floor Your Attic Without Wrecking Your Roof, Curtain Rods: Hang Them Without Drilling Holes, Episode #2034: Garage Organization | Winter-Ready Fireplace | Best Replacement Furnaces, Episode #2033: Best Kitchen Lighting | Are Foreclosed Homes Worth Buying? Some squeeze tubes may have a seal under the nozzle cap that will need to be removed or punctured before use. Your email address will not be published. Assemble the faucet following the manufacturer’s instructions. Unhook the lift rod for the drain stopper.
Your email address will not be published. Begin by scrubbing and cleaning the area around the sink. All information is provided "AS IS." Release the trigger when it reaches the handle.